You need a 1/2 of felt, a piece of cross stitch plastic, some regular thread and embroidery thread
Start with the cross stitch plastic. Cut it into 5 pieces, the bottom of the valet, and the 4 sides. Here are my dimensions:
Next, you need to cut a piece of felt out for the top and bottom of each piece. Cut each with extra felt because you will be sewing around the plastic inside so you will need the extra fabric. I started with the bottom - for the sides I folded the felt over so it was less cutting for me. Also on the bottom piece, I personalized the inside with a little embroidered heart. That is optional but definitely do it before sewing because it will be too thick with the plastic inside.
Layer all of the pieces together (felt-plastic-felt) and pin them together to get ready to be sewn. Pin them as close to the piece of plastic as you can. You will sew right along the edge of the plastic.
It doesn't matter if the edges aren't straight on the fabric for this step because they will be trimmed later. Now sew the plastic sandwich together. Remember as close to the plastic as you can get your needle!
All of your pieces are done, now you have to hand sew them together with embroidery thread. Trim each piece so that there is only about 1/4" of fabric on the edge. Use that 1/4" to sew the valet together. I started with the long sides to the bottom then the short sides to the bottom. Then I sewed the sides together last.
There you have the husband valet, which my husband actually uses by the way!